The Nanoscale World

Force distance measurement of hard samples in Contact Mode on Catalyst

rated by 0 users
Answered (Verified) This post has 1 verified answer | 6 Replies | 2 Followers

Top 100 Contributor
9 Posts
Points 132
Tejasvi Parupudi posted on Mon, Mar 12 2012 3:37 PM

Can anyone provide the procedure (a pdf, preferably) for taking force-distance and force-volume measurements using the Catalyst? 

Thanks in advance.

 

Tejasvi Parupudi

Purdue

  • | Post Points: 12

Answered (Verified) Verified Answer

Answered (Verified) replied on Mon, Mar 12 2012 4:25 PM

Hi Tejasvi,

The basic procedure is the same.

Stefan

  • | Post Points: 13

All Replies

replied on Mon, Mar 12 2012 3:43 PM

Hi,

Did you check the manual? It would be very helpful for us to know what is not clear in the manual so it can be improved upon in a later version.

Thanks,

Stefan

  • | Post Points: 12
Top 100 Contributor
9 Posts
Points 132

I have found the Force Spectroscopy Chapter in the Catalyst Experiment Guide but the method in there is for soft samples. I want to do a force-distance curve in contact mode in air on Silicon; so was hoping to find a application note or support note that details this procedure. 

Thanks,

Tejasvi

Tejasvi Parupudi

Purdue

  • | Post Points: 14
Answered (Verified) replied on Mon, Mar 12 2012 4:25 PM

Hi Tejasvi,

The basic procedure is the same.

Stefan

  • | Post Points: 13
Top 100 Contributor
9 Posts
Points 132

I was able to do it.

Thanks Stefan.

Tejasvi Parupudi

Purdue

  • | Post Points: 12
replied on Mon, Mar 12 2012 4:48 PM

No worries. Good luck with your experiments.

 

Stefan

  • | Post Points: 10
Top 50 Contributor
19 Posts
Points 215
Luis replied on Mon, Aug 13 2012 2:54 PM

Hi Tejasvi, I have also done force-distance curves in contact mode in air on Silicon. I'm new in the subject and it would be nice if you could take a look at my results to check if they are similar to yours. In the graph below I show the mentioned force-distance curves for three different tips, where the slopes of the linear curves are shown in the labels. Which tip have you used?

A few issues:

(a) I was surprised to obtain quite similar results for the sensitivity irrespective of the tip used.

(b) While approaching I would have though that the softer cantilevers (smaller spring constant) would have had a larger step when reaching the surface; however I observe the opposite.

(c) I do not understand the slow release effect that show the Antimony (n) doped Si tips when retracting.

If anyone else would like to comment I would also appreciate it,

Thanks in advance!

Luis

  • | Post Points: 10
Page 1 of 1 (7 items) | RSS
Copyright (c) 2011 Bruker Instruments