The Nanoscale World

Sharp STM tips

rated by 0 users
Not Answered This post has 0 verified answers | 2 Replies | 0 Followers

posted on Thu, Jan 7 2010 5:20 PM

How would one get or make STM tips with the following characteristics:
-apex has 1 nm radius of curvature (or less)
-opening angle (or cone angle) in the 5 nm above the apex is less than 60 degrees (full angle)
-tip material is stable in air
-can achieve atomic resolution

All Replies

replied on Thu, Jan 7 2010 5:20 PM

The two main types of STM tips seem to be W and Pt-Ir. W oxidizes in air, Pt-Ir does not (are you doing STM in air or UHV?). I've seen where people used W tips etched in HF just prior to scanning and they lasted a little while before oxidizing.


Usually W tips are electrochemically etched, usually Pt-Ir tips are cut/torn (although they can also be etched).


I would think that using electrochemical etching (where you control the voltage/current and can move the sample in/out of the solution) you could control the tip characteristics as required.


  • | Post Points: 10
replied on Thu, Jan 7 2010 5:23 PM

You may want to check out Bob Wolkow's method for making tips

[M. Rezeq, J. Pitters and R.A. Wolkow, J. Chem. Phys. 124 (2006), p.

204716]. He reports the process working with tungsten.


  • | Post Points: 10
Page 1 of 1 (3 items) | RSS
Copyright (c) 2011 Bruker Instruments