Forums
Bruker Media
Community Media
Bruker AFM Probes
SPM Digest
Application Notes
NanoTheater
Website
中文
Brochures & Datasheets
Publications
Probes Catalog
Events
Manuals & Documentation
Presentations
Guide to AFM Modes
News
Journal Club
Webinars & Video
Nanovations
Other
Hi,
I am using a DAQ card to read the general I/O outputs 1 and 2 from the front panel of the nanoscope V controller. Now I want to use the DDS3 Output to read a third low frequency analog signal, which I will select using the nanoscope software. Can you please tell me how I can enable the DDS3 to be used as a low frequency analog output?
best regards,
Umar Khan.
Umar,DDS3 is indeed a low frequency analog output so you should be able to simply turn it on using the “Generic Lockin” control panel in the SW. This is described in the manual. The only caveat is that in some modes (such as PFM or QNM) DDS3 is used at part of the mode and therefore unavailable. Hope this helps, if not please repost where you are getting stuck and what mode you are in.Steve