Problem with "Point and shoot"

wjzheng1 posted on Sun, Jul 29 2012 12:42 PM

rated by 0 users

I am using ScanAsyst in Fluid. I want to image the surface and probe several points of interest and get the force curves.

My problem is that when I clicked "Point and shoot" button, after marking the points, the "Ramp and Capture" button was dead, only "Ramp Only" worked. So I cannot capture the force curves after ramping, and the file was not aumatically saved, and there was no ".mca" file in my directory.

 What I did was I engaged the tip first, set the right scan size, and then clicked the "Point and shoot" button. I am not sure if I forgor any step to run "Point and shoot"?

Thanks very much if you have seen my problem and help.